6.6.
Throttle.
6.6.1.
Move the throttle lever on the handlebar to the
start position. N.B. In the start position the cutter
blade is dis-engaged.
6.6.2.
Keep the throttle at idle for about 2 minutes to
allow the engine to warm up.
6.7.
Operator presence bar.
6.7.1.
This must be held towards the handlebar to start engine. If it is released the
engine will not run.
6.7.2.
If you release the operator presence bar, the ignition system will cause the
engine to stop.
6.8.
Brake lever.
NEVER operate a machine with a defective brake.
6.8.1.
The brake must always be ON when starting and using the stump cutter.
6.8.2.
The brake lever activates a disk brake on the left wheel when it is pulled
backwards. The brake should always be in the ON position when in operation,
when it’s parked and when it’s being transported.
6.9.
Starter handle.
6.9.1.
Misuse of the starter handle can damage the starter.
6.9.2.
DO NOT twist the starter cord around your hand.
6.9.3.
Pull out the handle slowly until you feel a slight pressure.
6.9.4.
Then give a steady sharp pull on the starter handle.
Repeat until the engine starts.
6.9.5.
DO NOT pull out the starter cord completely and DO
NOT
let go of the starter handle when extended.
Page 15
Summary of Contents for HYSG150
Page 1: ...STUMP GRINDER Model HYSG150 User Manual ...
Page 2: ...Page 2 ...
Page 27: ...Page 27 ...