Hyundai HYBC5200, User Manual

Page: 26 / 40

f. The shoulder strap is fitted with a
quick release device (see image) fitted.
You can remove the shoulder strap quickly
by pulling the quick release device.
5.4. Trimming techniques.
If you are not familiar with the trimming,
practice with the machine with the
machine stopped.
5.4.1. Always trim or cut with the engine
running at high speed.
5.4.2. Do not run the machine slowly
except for when warming up before use or
cooling down after use.
5.4.3. Swing the nylon cutting head of the
trimmer horizontally from left to right.
5.4.4. Keep cutting deck parallel with the
ground. Do not tilt the nylon cutting or
blade head during operation.
5.4.5. For correct cutting height trim a
test area in advance.
5.4.6. Keep nylon cutting or blade head at
the same level for an even depth of cut.
5.4.7. Nylon trimming head is only to be
used for trimming grass.
5.4.8. Metal blade head is only to be used
for cutting brush.
5.4.9. To prevent overheating NEVER
over cut, instead cut off smaller lengths of
grass or brush. You MUST also remove any
tangled materials – You MUST stop the
machine and remove the HT lead before
carrying out this task.
5.4.10. When trimming around trees trim
slowly making sure that the nylon cord
does not come into contact with the trunk.
Walk around the tree from left to right and
approach grass with the tip of the cutting
nylon cord.
5.4.11. To release more nylon cutting cord
run the machine at full throttle and tap the
nylon cutting head on the grass. The nylon
cord is then released. Any excess cord is
cut off by the trimmer blade mounted on
the guard. When trimming near brick or
stone walls the nylon cord will wear out
quicker.
Page 26 Rev 3 - September 2016