Hyundai HSH-121NBE, Service Manual

Page: 65 / 259

Time
r
changing:
Set temperature T
preset
1 hour
2 hour
Over 2 hours
l
T
preset
Set temperature
T
preset
T
preset
T
preset
T
preset
T
preset
T
preset
2 hour
1 hour
Over 2 hours
If the system is under timer state, the unit can be turned on/off by ON/OFF button on remote controller. Timer can be reset and the
system will run according to the final setting.
If timer ON and timer OFF are set at the same time under running status of the system, the system will keep the current running status.
When timer OFF reaches, the system will be stopped.
If timer ON and timer OFF are set at the same time under OFF state of the system, the system will keep the current stopping status.
When time ON reaches, the system will start running.
Later, the system will run in setting mode when time ON reached and will be stopped when timer OFF reaches. If the setting time
for timer ON and timer OFF is the same, time OFF previals.
(3)Buzzer
(4)Sleep Function
(2) Auto
Button
When pressing
this button
once, the system will start
running at
aut
o
mode, the indoor fan will
run
according
to the auto
fan speed. T
he swing motor will
run
when the indoor fan is
running
. The system will
be
stop
ped
when pressing
this button
again.
Upon energization and operation, the buzzer will give out a beep.
Under cooling or dehumidifying mode, the
setting
temperature will automatically
increase
by 1 ć one hour after setting of sleep
function
and
increase
by another
1
ć after 2 hours
. It will increased by
2 ć
at all
within two hours. Then
the unit
will continu
e to
run
according to
this setting
temperature.
Under heating mode, the
setting
temperature wi automatically decrease by 1 one hour after setting of sleep
function and decrease by another 1 ć after 2 hours.
It will be decreased by
2 ć
at all
within two hours.
Then
the unit
will c
ontinue to run
according to
this setting
temperature. (
this isn't available for cooling only unit
)
ć
(5) Turbo Function
It is available to set the turbo function under the heating and cooling modes.
(6)
Blow
Function
It is available to set the
blow
function under the heating and cooling modes.
(7) Automatic Control of Fan Speed
Under this mode, the air conditioner can automatically select the speed of indoor fan (high, medium or low) with the change of
ambient temperature.
(8)Swing Motor Control
After being powered on, the swing motor firstly makes the
guide louver
rotated to position 0 anticlockwise, and the air
outlet
will
be closed.
After starting
the unit
, if the swing function has not been set, under the heating condition, the up
&
down
guide louver
will be rotated to D position
clockwise. Under other conditions, the up
&
down
guide louver
will be rotated to horizontal L position.
When setting the
swing
function at the time of starting
the unit
, the
guide louver
will swing between L and D. The
guide louver
has
seven kinds of swing conditions: position L, position A, position B, position C, position D, swinging between position L and D, and
stopping in any position from L and D (the included angle of L-D is equiangular)
The
guide louver
is closed at the position 0
when turing off the unit
. The swing action will be only effective when the swing order
is set and the indoor fan is in operation.
Note: When the remote control
ler
is set to be in the position L to D, the position A to C, and the position B to D, the
guide louver
will
swing between the position of L and D.
63