18
Original Instruction manual
Extended storage:
1.
Remove all water connections
2.
Allow the cleaner to function for a few seconds in order to remove the remaining water.
3.
Drain the fuel from the cleaner.
4.
Be careful not to bend the flexible high pressure.
5.
Keep the cleaner and accessories in a place where the temperature does not drop to -0 °.
6.
To avoid any risk of fire or burn, let the engine cool before transporting the cleaner or keep it
inside a house.
When transporting the machine, it is necessary to close the fuel valve, keep the cleaner on a flat
surface and make sure the tank cap is closed and is in good condition. This is because of spilled
gasoline and gasoline vapours which can cause fire.
WARNING
: If these instructions are not followed, it could damage the pumps, equipment and accessories.
How to use the high-pressure cleaner
WARNING!
Firmly hold the gun while pulling the trigger. Warning! The force of the recoil can make you lose your
balance. Use both hands to hold the gun.
Cleaning the deck of a boat
(With or without detergent)
Clean the deck with fresh water as well as its surrounding platform. If using detergent, place detergent
suction tube directly into cleaning solution and apply detergent on the surface with the low pressure nozzle.
For best results, limit the cleaning area to smaller sections; allow the detergent to react for 1 to 3 minutes. Be
careful not to let the surface dry with the detergent. Then rinse with high pressure in a long sweeping motion
keeping the spray nozzle at about 40 cm from the surface to be cleaned. Always clean from bottom to top
and from left to right. When moving from one section to another, ensure to overlap the previous section to
eliminate stop marks and ensure satisfactory cleaning results.
Cleaning house facades
(With or without detergent)
Clean the surface with fresh water. If using detergent, place detergent suction tube directly into cleaning
solution and apply detergent on the surface with the low pressure nozzle. For best results, limit the cleaning
area to smaller sections, and always apply detergent from bottom to top, allow the detergent to react for 1-3
minutes. Do not allow detergent to dry on the surface. If the detergent has become more or less dry, simply
wet facades with fresh water. If necessary, use a special brush to remove sticky dirt. Then rinse high
downward pressure in a long sweeping motion keeping the spray nozzle at about 40 cm from the surface
being cleaned.
