18
Troubleshooting
Environment and recycling
Electrical devices do not go into the
domestic rubbish. Give devices,
accessories and packaging to an
eco-friendly recycling.
According to the European Directive 2012/19/EU
on electrical and electronic scrap, electrical
devices that are no longer serviceable must be
separately collected and brought to a facility for
an environmentally compatible recycling.
Technical Data
Power supply voltage :
230V~50Hz
Power consumption :
1000 W
Idle speed :
380 min
-1
Working width :
360 mm
Working depth max. :
200 mm
Sound level at work-place L
PA
75.4 dB(A)
K = 2.5 dB(A)
Measured sound power level L
WA
88.07 dB(A)
Guaranteed sound power level L
WA
93 dB(A)
Vibration :
0,901 m/s
2
K = 1.5 m/s
2
Weight :
8.5 kg
Problem
Possible causes
Remedy
No electricity
Check mains connection
Defective cable
Check cable, plug in, replace if required, or have it
repaired by a qualified person
Defective safety switch/plug
combination
Arrange for repair in a specialist workshop
1. Working depth too large, set to the shorter depth
2. Blades blocked, remover the blockage
3. Soil too hard, select correct work depth and
forwards and backwards several times while slowly
down the operation speed.
Motor does
not start
Overheat protection actived
wait till the motor cool down for around 15 minutes
before rework
Blade is jammed
Switch off wait till complete stop. Remove the objects
Lubrication running out
Arrange for repair in a specialist workshop
Abnormal
noises
Loose bolts, nuts or other
securing components
Tighten all components, contact specialist workshop if
noises prevail
Blades damaged or worn
Replace or have it checked by an specialist workshop
Abnormal
vibrations
Working depth too large
Set to correct working depth
Working depth too small
Set to correct working depth
Poor
scarification
results
Worn blades
Replace or have it checked by an specialist workshop
