www.hhigreen.com
Page 2 of 18
Sales Office
Bundang First Tower, 55, Bundang-ro,
Jongno-gu, Seongnam-si, Gyeonggi-do
13591, Korea
Factory
313, Soi-ro, Soi-myeon, Eumseong-gun,
Chungcheongbuk-do 369-872, Korea
2.2 Notice
·
Installing solar photovoltaic systems requires specialized skills and knowledge, and should only be
performed by qualified persons.
·
Each module has a junction box for permanent cable connection. HHIGE can provide customers with
fitted cables for easy installation. Installers should secure the safe installation status including all
electrical hazards.
2.3
·
Installers should secure the installation status, without limitation, including the risk of electric shock.
·
Back sheet of PV module should be kept safe from any damage or scratch to prevent mechanical or
electric shock.
·
Do not disassemble or remove any part of a PV module or such actions may cause electric shock,
fire or damage.
·
Keep safety regulations for all components used in the system, including wiring and cables,
connectors, charging regulators, inverters, storage batteries and rechargeable batteries, etc.
2.4
·
Before installation, prevent the module from exposure to direct sunlight or other light source. (If
modules are exposed directly to sunlight without connection, each module generates over DC 30V,
which is potentially hazardous.)
·
Modules are heavy. Be sure to have more than two persons with anti-slip gloves on carry each PV
module. Do not throw and drop PV modules.
·
Do not sit, stand, step, walk and/or jump on the module, including the frames.
·
Do not drop or place objects on the modules. Do not place excessive loads on the modules or twist
the module frame.
·
All installation equipment and PV modules must be kept in dry condition during installation.
·
Check the current and the voltage before connecting the line. There is potential hazard in case of
higher voltage in series connection and higher current in parallel connection.
·
All PV modules must be earthed by using earth device. Safety check for all other parts of systems
should be finished before installation to prevent any electric hazard.
·
Do not use any damaged PV module, where it may cause fire, electric shock or injury.
·
Do not focus light on a PV module, where it may cause fire and damage.
·
Do not touch live parts of wires, cables, connectors, or junction boxes, in order to prevent electric
shock and injury. Be sure the circuit breaker is off if it’s applicable. Always use appropriate safety
equipment. (Insulated tools, insulating gloves, etc.)
·
Do not re-arrange bypass diodes, where it may cause electric shock and injury.
·
Do not disconnect the cable when the load to module is engaged.
·
Check applied Class for module after installing the module.
·
Do not remove any labels.
