Removing the collected water
Operating
Instructions
There are two ways to remove collected water
.
1. Use the bucket
· When the bucket is full, the unit will automati-
cally stop running, and the Full indicator light
will flash.
· Slowly pull out the bucket. Grip the left and
right handles securely , and carefully pull out
straight so water does not spill. Do not put the
bucket on the floor because the bottom of the
bucket is uneven. Otherwise the bucket will
fall and cause the water to spill.
· Throw away the water from the water outlet
and replace the bucket. The bucket must be
in place and securely seated for the dehumid-
ifier to operate.The machine will re-start when
the bucket is restored in its correct position.
1. Pull out the bucket a little.
2. Hold both sides of the bucket with even
strength, and pull it out from the unit.
Water can be automatically emptied into a floor drain
by attaching the unit with a water hose(
Φ
16.5*13.5
mm)(not included).
· Remove the plastic konck-out panel from the upper
side of the bucket.
· Make sure the water hose is lower than the drain hose
outlet.
2. Continuous draining
Note:
· When you remove the bucket, do not touch
anyparts inside of the unit. Doing so may
damage the product.
· Be sure to push the bucket gently all the way
into the unit. Banging the bucket against
anything or failing to push it in securely may
cause the unit not to operate.
· When you remove the bucket, if there is some
water in the unit you must dry it.
Note:
· When the continuous drain feature is not being
used,remove the drain hose from the outlet.
· Use needle nose pliers if the plastic panel is too difficult
to remove by hand
.
· Burrs may hurt hand while connecting the drain hose.
Please using a reamer or a deburring tool to remove
all burrs from the cut section of the panel
.
3. Pour the water out.(The bucket of the unit you
purchased may be slightly different)
Water outlet
Do not block water flow by a rise.
Do not block water flow by a retortion.
· Insert the water hose into the unit from the drain
outlet in the back of the unit.
· Attach the water hose to the drain hose outlet of the
unit.
· Make sure the connection of the water hose and the
drain hose outlet of the unit is tight and do not let the
water leak.
Remove the
konck-out panel
Insert the water
hose from the
drain outlet
Remove all burrs from
the cut section of the
panel
.
· Then lead the water hose to the floor drain or a
suitable drainage facility .The drainage facilify should
be lower than the drain outlet of the unit. Be sure to
run the water hose sloping downward and let the
water to flow out smoothly . Do not install the water
hose.
Page 15
Summary of Contents for HDR 12 IVA
Page 1: ...UPUTSTVA ZA KORI TENJE USER MANUAL HDR 12 IVA...
Page 20: ...USER MANUAL HDR 12 IVA...
Page 39: ......