EN
23 / 31
22
Cutting hair with the use of the attachments
1. We recommend first trying the attachment
B4
and only then, if you wish for a shorter cut,
use the attachment
B1, B2, B3
. Always turn the clippers with a switch
A1
before changing
the attachments.
2. Comb the hair in the direction of its natural growth.
3. Start cutting by shortening the hair on the sides from below to the top. Guide the trimmer
slowly against the hair with the adapter leading upwards, but flatwise along the head. Lift
up the appliance slowly and offward head. Cut only small volume of hair in each stroke.
4. Repeat step 3 on the sides and on the back around the whole head.
5. Start trimming hair on the top of the head from front to the back with the adapter teeth
held along the head. In the first couple of trimmings it is recommended to leave hair
longer.
Cutting contours
1. No adapter is used for aligning contours.
2. Comb the hair in the required style.
3. Set the trimmer between hairline and ear. Check whether the corner of the trimmer blades
is set against hairline. Follow the hairline and go round the ear slowly with the trimmer
upwards and to the back. Do not push on the trimmer.
4. At the back on the neck and by the sideburns, hold the appliance against the skin and go
down at the required length.
Note:
When using the device without attachment, you can change the haircut length with the lever
A2. The length range in this case is approx. 2 – 5 mm.
Short military cut
1. Always cut from the scruff to the head top using the longest setting. Hold the trimmer
flatwise along the head and move it slowly through the hair upwards. Apply the same
procedure on the head sides; even here move the trimmer bottom-up.
2. On the front part of the head top, cut the hair against the growth direction. Then align the
cut against the cut on the temples.
3. If you want to reach even cut on the top, cut the hair using a straight comb, not the
trimmer adapter. Use the comb for cutting hair on the top of the head.
4. To shorten the cut towards the neck, gradually use shorter adapters. Comb through the
hair and look for unevenness in the cut. Align the cut by the neck and at the ears.
5. If you want to reach graduated short cut along the sides of the head and on the neck,
follow the instructions on fig. 3.The mentioned main areas on the figure are your map for
becoming an amateur barber easily.
Trimming beard
1. Before trimming beard, wet it a bit and comb it.
2. Mark the beard line using the trimmer and cut out the beard exceeding the line on the
outside.
3. If you want to reach even beard cut, use one of the B adapters or trim the ends carefully
in parts using a comb by moving the comb through the beard upwards (fig. 2A). Repeat
the process on the whole beard.
4. After the end of trimming, shave the area around the beard in a usual way.