3-19
Con
venient f
e
atur
es of y
our v
ehicle
Operation and obstacle detec-
tion
The electrical step (1) is equipped
with a device to detect an obstacle in
front.
When the electrical step comes into
contact with an obstacle while
extending out, its movement auto-
matically stops with 'short but repeti-
tive' warning alarms.
To fully extend out the electrical step
again, take the following steps. First,
remove the obstacle. Second, close
and then re-open the mid-sliding
door. Finally, repetitively press the
STEP switch to turn OFF and turn
ON the electrical step.
If the electrical step hinders load-
ing, you can block the step when
opening the sliding door by using
the obstruction detection. This
means that the electrical step
remains retracted and a fork-lift
truck or another lifting vehicle can
move closer to the load compart-
ment.
Electrical step warning alarm
1.Continuous beeping sound
You will hear this type of alarm,
whenever the electrical step oper-
ates.
2.Short beeping sound (short &
repetitive)
You will hear this type of alarm,
when the parking/foot brakes are
released.
In this case, apply the parking/foot
brakes for your safety.
3.Long beeping sound (long & repet-
itive)
You will hear this type of alarm,
when the operation of the electrical
step temporarily fails due to opera-
tional/electrical problems.
In this case, remove foreign sub-
stances, such as sand, mud, and
ice. Then, re-press the STEP
switch to operate the electrical
step.
However, if the problem persists,
manually push in the electrical step
as a safety measure. Still, we rec-
ommend you to have the electrical
step repaired by an authorized
HYUNDAI dealer.
NOTICE
3
Never drive your vehicle, when
the electrical step is extended
out. It may cause an accident,
strike with other vehicles, and
even injure passers-by. Always
drive your vehicle with the elec-
trical step fully retracted in.
WARNING
