![background image](http://html1.mh-extra.com/html/hyundai/h-lcdvd3200/h-lcdvd3200_instruction-manual_2197557019.webp)
18
19
Operation
General information
Troubleshooting
Below is a table describing simple measures that can help you eliminate most problems likely
to emerge when this unit is in use. If below measures do not help, turn to a service center or to the
nearest dealer.
Symptom
Cause
Solution
No picture, no
sound, and no
indicator light
The power cord is not plugged in.
Contrast, brightness, sharpness, color
and volume are all in the minimum
value or TV is in mute mode.
Plug the power cord in.
Alter the value of contrast,
brightness, sharpness, color and
volume.
Picture and
sound with
abnormity
Contrast and color are set improperly.
Color system is set improperly.
Sound system is set improperly.
Set the value of Contrast and color
properly.
Set the sound system properly.
Picture is spotted
or with snow
Signal source is low-grade or the
signal is in a lower quality.
Use the qualified signal cord.
Blue background No video signal or the signal cord is
improperly/not connected.
Connect the signal cord properly.
PC Picture is not
in the middle of
the screen
Picture is not well adjusted.
Press the CH+/CH- buttons at one
time to adjust it.
Adjust H/V position manually to
adjust it.
No sound
No audio signal or the signal cord is
im-properly/not connected.
Connect the audio signal cord
properly.
Set the sound system properly.
Disc playing
abnormally
Disc dirty or scratched.
Clean or change the disc.
Disc not playing
Disc placed upside down.
Turn the disc right side up.
The RC does not
work
Batteries are improperly installed or
exhausted.
Make sure the positive and the
negative polarities are correct.
Reattach the battery lid.
Replace the batteries.
Causes of interference
Incorporated in your TV receiver are the most up-to-date devices to eliminate interference.
Local radiation however, can create disturbances, which visibly affect your picture. Proper
installations, a good aerial are your best safeguards against these disturbances.
• RF INTERFERENCE: Moving ripples across the screen are caused by nearby transmitting or
receiving short-wave radio equipment.
• DIATHERMY: Herringbone pattern and partial picture loss can result from the operation of
diathermy equipment from a nearby doctor’s surgery or hospital.
• SNOW: Weak TV signals from long distant stations result in an instead picture and give the
Summary of Contents for H-LCDVD3200
