IM2021
22
•
To remove water on small parts,
you can use a brush and then wipe them again with a soft
cloth.
•
Clean the device once or twice a week.
•
If dirt is formed on the membrane, clean it with a brush.
•
Rinse the water tank cover and nozzle carefully and effortlessly with fresh water, otherwise
this will cause water to leak through the cover.
•
After removing any remaining water from the surface of nozzle, wipe it with a soft cloth.
•
Clean the outside of the appliance with a damp and soft cloth.
IMPORTANT!
•
To avoid deformation of working surfaces, resulting in decreased atomizing or other
malfunctions, do not use metallic brushes, blades or talc powder to wipe the atomizer’s
surface.
•
The water tank may leak after heavy impacts.
•
In case of water leakage, immediately stop using the unit and contact an authorized service
center.
•
To keep the unit dry, wipe the water after cleaning and dry the unit’s base and water tank.
Make sure that there is no water left inside the unit’s base and water tank.
•
Before a long
break in use, dry the base and the tank, but the tank on the base and pack the
device in a plastic bag, then put it in a box.
•
Store the unit in a low
-
humidity room.
•
Storing the unit undried results in generation of mold.
To clean the water tank and parts of the base of the device from salt deposits, use citric acid:
•
for 1 liter of hot water, take 1 tablespoon of citric acid and mix well;
•
pour the solution into the tank and put it on the base of the humidifier (water from the tank
will automatically fall into the base of the device);
•
leave the humidifier for 10
-
12 hours
-
do not turn it on;
•
after the time has passed, remove the solution from the device along with the exfoliated
parts of the salt coating;
•
if it is difficult to remove plaque
-
use a special brush for the base of the humidifier (if this is
not supplied, you can use a toothbrush). For the tank
-
pour 0.5
-
1 cups of dry rice into cold
water or a cooled citric acid solution and shake until the plaque is peeled off;
•
rinse all internal parts of
the device with cool water;
•
use a humidifier as usual after the procedure.
How to clean ceramic filter:
•
Clean and activate the ceramic ball filter after using 1000L water regularly. Depend on water
quality, if ceramic balls are dirty, the filter needs to be cleaned more frequently.
•
It can be dipped in vinegar about 5 minutes. Then rinse it cleanly with clean water.
•
Put the filter under the sun for 4~6 hours.
•
You can purchase replacement filters.