3
Instruction manual
Clock setting
• In standby mode press TIME button to
enable time setting mode. Hour digits will blink;
press repeatedly
/
buttons to set hours.
Press TIME button again; minute digits will
blink. Press repeatedly
/
buttons to set
minutes. Press TIME button again; week days
will blink. Press repeatedly
/
buttons to
set the day of the week. Press TIME button to
confirm the time.
• The time of this unit can also be
synchronized with the system time of iPod/
iPhone/iPad. Connect your iPhone/iPad to this
unit, time synchronization will be performed
automatically. 1 minute difference is possible to
have between the sync time of this unit and time
of your iPad/iPhone.
AUX input
You can connect the audio output of an
external device to this unit, to listen to the sound
of that device through the speakers of this unit.
• To connect an external audio device,
please use a standard audio cable with 3.5-mm-
to-3.5 mm plugs to connect the headphone out
or audio line-out of the external device to the
AUX input socket of this unit.
• Press repeatedly MODE button to select
AUX mode; AUX will be displayed.
• Turn on the external device. You cannot
control playback with the buttons of this unit
except adjusting the volume.
Volume
Press +/- buttons to adjust the sound volume
level.
Modes
Press MODE button repeatedly to select an
operation mode: Radio => iPod => USB => SD
=> AUX.
Display backlight
Press SNOOZE button repeatedly to change
the display backlight brightness level or switch
off the backlight.
• Do not expose the unit to vibration, direct
sunlight, too high or low temperature or humidity.
• Do not disassemble the unit yourself.
Refer servicing to qualified service personnel.
• When the battery is exhausted, it should
be removed from the set to prevent leakage.
Power supply
AC power
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Insert the plug into power supply.
Caution:
Always unplug the appliance from
power supply, when no use long time.
Battery power
• Open the battery compartment cover.
Insert 2 x UM4/AAA (not included) batteries
(not included). Please observe correct battery
polarities or the unit will not work. Close the
battery compartment cover.
• This is additional power intended for
maintenance of clock and alarm settings.
Without the additional power clock and alarm
should be reset anew after each power-off.
• When the batteries are exhausted they
should be replaced. Replace the batteries only
with batteries of the same type.
• Do not use new and old batteries together.
General operations
Power on/off
When the unit is connected to the current
supply mains, the unit goes into standby mode;
the display shows clock. Press button
to switch the unit from standby mode; the
backlight will light up and the mode radio will be
activated. To switch the unit to standby mode,
press and hold button. To switch the power
off, disconnect it from the electriccal mains.
Summary of Contents for H-AS1202iu
Page 13: ......