4
Instruction manual
spinning before opening the CD-door.
• To remove a disc, follow the same
procedure as described above, except to
remove the disc instead of inserting it into the
compartment, by placing one finger at the
middle of disc (center spindle) and the other at
the edge of the disc and gently pulling upwards.
Always hold a disc by its edges. Avoid
getting any fingerprints, smudges or dirt onto
the surface of a disc. In case this happens, use
a special CD-cleaning cloth or cleaning kit to
remove the dirt or smudges. Please make sure
to always fold down the handle before opening
the CD door.
General operation
• Set FUNCTION switch to CD (MP3)
position.
• Put a disc into the CD compartment and
close the CD door.
• The LCD display will show the total number
of tracks after a few second. If the MP3 disc
contains folders, the display will show the folder
number (e.g. “F01”) every five seconds.
Play/pause mode
• Press PLAY/PAUSE button to start play, the
LCD display will show the first track number.
• Press PLAY/PAUSE button to pause at
any track when playing, Press the button again
to resume playback.
• To stop the disc, press STOP button.
• If the MP3 disc contains folders with files,
select a folder by pressing and holding SKIP+10/
FOLDER button. If the disc has no folders, press
this button to skip 10 tracks forward.
Skip and search mode
• Press NEXT button once to skip to the
next track.
• Press BACK button once to skip back to
previous track.
• Press and hold BACK and NEXT buttons
to start fast backward or forward playback until
you find the passage to play from.
Repeat mode
• Press REPEAT/PROG button once for
single track repeat playing.
• Press REPEAT/PROG button again for all
tracks repeat playing.
• Press REPEAT/PROG button again for
current folder tracks repeat playing (onlt if the
MP3 disc contains folders).
• To cancel repeat play, press REPEAT/
PROG button once again.
Program mode
• Up to 20 tracks (for CD) or 99 tracks (for
MP3) can be programmed for disc play in any
order. Before use, be sure to press STOP
button.
• Press REPEAT/PROG button, the memory
position number will show on the display.
• Select a desired track by using BACK and
NEXT buttons.
• Press REPEAT/PROG button to confirm.
• Repeat the two last steps as described
above to enter additional memories into the
program if necessary.
• When all the desired tracks have been
programmed, press PLAY/PAUSE button to play
the disc in the order you have programmed.
• To stop the CD, press STOP button.
The program memory will be cleared only
when the CD compartment is opened or turn off
the CD or power supply.
• To turn off the CD player set FUNCTION
switch to TAPE (OFF) position.
Good quality sound is guaranteed only
when playing licensed discs.
Cassette playback
• Slide FUNCTION switch to TAPE (OFF)
position.
• Press
button to open the cassette
compartment.
• Insert a cassette and push the cassette
door to close the cassette compartment. The
full tape reel should be on the right side.
• Press button to start playback.
