16
5. Set the STOP switch to position "I". Make sure the cutting head is clear. Store the
machine on a level, solid floor.
6. Keep the machine on the ground safely and then pull the starter until the engine starts
WARNING
The machine is equipped with a centrifugal clutch system.
When starting the engine, place the machine on a level, clean floor and hold it
firmly to prevent the sharp components or the throttle lever from coming into
contact with any objects when the engine is started.
IMPORTANT
Avoid pulling the starter to the end or return the cable by suddenly releasing its
handle. This can cause the engine to fail.
Position the choke in the "open" position and restart the engine.
Let the engine warm up a few minutes before starting work.
NOTE
When restarting the engine directly after stopping it, keep the choke switch in the
"open" position.
Overheating complicates engine starting due to overfilling of fuel. If the engine does
not start after several attempts, open the starter and press the starter several times,
or remove and dry the spark plug.
B) Stop the engine
Release the throttle lever and let the engine run for about 30 seconds.
Set the stop switch to the STOP position.
IMPORTANT
•
Except in case of emergency, do not switch off the engine by pulling on the choke lever.
•
If the engine does not stop by pressing the stop switch, move the choke to the closed
position.
Disassembly of the cutting element
-
Align the hole in the dust cover (fig.1) and the notch under the blade holder; insert the Allen key to
4 to secure the assembly.
-
Remove the cutting blade safety screw using the supplied spark plug wrench (fig 2).
Important: Caution, risk of injury to the left hand!
