Subject to change without notice.
Edition: 26 Feb. 2020 Ver. A0 Page 4/5
Detection range
Press buttons in zone “Detection range” to set detection range at 100% / 75% / 50% / 10%.
1. Press button “Shift”, the red LED starts to flash.
2. Press button “Ambient”, the surrounding lux level is sampled and set as the new daylight threshold.
Ambient daylight threshold
Hold-time
Press buttons in zone “hold-time” to set the hold-time at 2s / 30s / 1min / 5min / 10min / 15min / 20min / 30min.
Note: 1. To set hold-time at 30s / 5min / 15min / 30min, press “Shift” button first.
2. 2s is for testing purpose only, stand-by period and daylight sensor settings are disabled in this mode.
*To exit from Test mode, press button “RESET” or any button in “Hold-time”.
Dual tech & RF mode
Stand-by dimming level
Stand-by time (corridor function)
Press buttons in zone “stand-by time” to set the stand-by period at 0s / 10s / 1min / 5min / 10min / 30min / 1h / +∞.
Note: “0s” means on/off control; “+∞” means bi-level control, the fixture is 100% on when there is motion detected, and remains at the stand-by dimming level
when no presence after motion hold-time.
Press the button in zone “stand-by dimming level” to set the stand-by dimming level at 10% / 20% / 30% / 50%.
All buttons are disabled.
Press the buttons to adjust the light brightness during hold-time.
Brig/-
Press buttons in zone “ Daylight threshold” to set daylight sensor at 2Lux/ 10Lux / 50Lux / 100Lux / 300Lux / 500Lux / Disable.
Note: To set daylight sensor at 100Lux / 300Lux / 500Lux, press “Shift” button first.
Daylight threshold
Wiring Diagram
L
N
SY
NC
SY
NC
P
DALI
L
N
DALI+
LED+
LED Driver
LED
DALI
L
N
DALI+
LED+
LED Driver
LED_
_
_
_
DALI
+
-
N L
SY
NC
SY
NC
P
DALI
+
-
N L
HMW25
HMW25
Auto-configuration function
All buttons in this zone are disabled.
