8000 SRM 707
Maintenance Procedures Every 250 Hours or 6 Weeks
Pitch
Total Length
of 20 Links
(Pitch) of New
Chain
Wear Limit
(The
Maximum
Length of 20
Links)
12.7 mm
(0.50 in.)
15.9 mm
(0.63 in.)
19.1 mm
(0.75 in.)
25.4 mm
(1.00 in.)
254.0 mm
(10.0 in.)
317.5 mm
(12.5 in.)
381.0 mm
(15.0 in.)
508.0 mm
(20.0 in.)
261.6 mm
(10.3 in.)
327.0 mm
(12.9 in.)
392.4 mm
(15.4 in.)
523.3 mm
(20.6 in.)
NOTE: INSTRUCTIONS FOR MEASURING CHAIN
WEAR ARE SHOWN ON CHAIN WEAR SCALE.
1.
CHAIN WEAR SCALE
Figure 22. Lift Chains Check
MAST
WARNING
When working on or near the mast, see Safety
Procedures When Working Near Mast in this
section.
NOTE:
The load rollers and sheaves have sealed bear-
ings and do not need additional lubrication.
1.
Lubricate sliding surfaces and load roller sur-
faces along full length of channels as shown in
Figure 23. Apply lubricant only to surfaces indi-
cated.
A. UPPER LOAD ROLLERS
B. LOWER LOAD ROLLERS
1.
LUBRICATE STRIP BEARING SURFACES
2.
LUBRICATE LOAD ROLLER SURFACES
3.
LOAD ROLLER
Figure 23. Mast Lubrication
2.
Lubricate pivot pins for mast at grease fittings
on mast. Use multipurpose grease.
3.
If a sideshift carriage is installed, lubricate slid-
ing surfaces at grease fittings with multipurpose
grease.
STEERING AXLE
Lubricate H45-65XM tie rod ends and kingpins on
steering axle. There are two grease fittings on each
tie rod. The grease fitting for each kingpin is on front
side of spindle. Lubricate S40-65XM spindle bear-
ings. There is a grease fitting for each spindle. Use
multipurpose grease at grease fittings.
FUEL SYSTEM
NOTE: This section covers the Diesel, Gasoline, LPG
(Impco), LPG (Aisan Open Loop), and LPG (Aisan
Closed Loop) fuel systems.
NOTE: The following adjustments are for engine
speed only. For adjustments to the gasoline fuel sys-
tem or to other parts of the fuel system used on the
GM 3.0L engine, see section GM 3.0L Electronic
Engine Control - Troubleshooting and Repair
(Early Models) 2200 SRM 611 or GM 3.0L and
37
