A.
BRAKE PEDAL POSITION SENSOR (LEFT
SIDE)
B.
PARKING BRAKE POSITION SENSOR (RIGHT
SIDE)
1. BRAKE PEDAL POSITION SENSOR MOUNT-
ING BRACKET
2. TORX SCREW
3. NUT
4. BRAKE PEDAL POSITION SENSOR
5. PARKING BRAKE POSITION SENSOR
6. LOCKWASHER
Figure 15. Brake Pedal Position and Parking Brake Position Sensors
4.
Remove two nuts, two torx screws, and brake
pedal position sensor from brake pedal position
sensor mounting bracket. See Figure 15.
Install
1.
Install new brake pedal position sensor, two
torx screws, and two nuts onto brake pedal po-
sition sensor mounting bracket. See Figure 15.
Tighten nuts to 2.25 N•m (20 lbf in).
2.
Connect brake pedal position sensor connector
to cowl harness as tagged during removal.
3.
After new service brake pedal position sensor
has been installed, check the gap between the
sensor arm and tab. See Brake System
1800SRM1743 for the procedure.
4.
Install kick panel and dash. See Dash Panel,
Kick Panel, and Seal Plate, Remove and Install.
Install upper steering column cover. See Dis-
play Switch Cluster.
5.
Connect the battery and lower the hood.
2200 SRM 1771
Sensors and Switches
15
