1. COAST CONTROL SWITCH
2. SIDE GLIDE SWITCH
Figure 16. Side Glide and Coast Control Switches
Remove the Coast Control Switches
1.
Remove the top cover. Refer to Remove Top Cover in
this section.
2.
Tag, identify, and disconnect the wiring from the coast
control switches.
3.
Disconnect the two leads from the switch at the wiring
connector. The individual switch wires must be re-
moved from the connector body to remove the switch
from the lift truck.
4.
Remove the locking nut and washer from the switch
body and remove the switch from the top cover.
ASSEMBLE
Install the Coast Control Switches
1.
Install the switch and wiring through the mounting
hole in the top cover.
2.
Install washer and lock nut removed during disassem-
bly.
3.
Connect leads from the switch wiring to the connector
body and reconnect the connector.
Install Side Glide Switches
1.
Install the switch to the switch base with the two
screws removed during disassembly.
2.
Connect the wiring removed during disassembly.
3.
Install the actuator and two springs into the cover.
4.
Place the switch base on the cover and install the as-
sembly to the handle with the two screws and washers
removed during disassembly.
Install Handle Shaft Assembly
1.
Slide the butterfly actuators onto the handle shaft and
engage the spiral pins in the shaft.
CAUTION
Make sure the lock rods are installed opposite
one another in capped slots of the butterfly actua-
tors.
NOTE:
Locking rods can be installed or removed depend-
ing on operational preference.
2.
If equipped, install the locking rods into the capped
slots of the butterfly actuators. Some slots of the but-
terfly actuators are open completely through and some
are capped at the end. Make certain that the rods are
installed in slots that are capped to hold the rod in
place. See Figure 17.
Figure 17. Capped Slots in Butterfly Knob
3.
Align the grips with the locking rods and install the
grips onto the handle shaft.
4.
Install the link from the throttle sensor into the shaft
sleeve and the throttle sensor assembly.
2200 SRM 1640
Control Handle (HD Option)
17
