1. PIN
Figure 14. Retaining Pin
7.
Remove the inner bushing supporting the throttle sen-
sor end of the throttle cam.
8.
Slide the cam out of the outer bushing. Take care to
ensure the throttle return spring tangs slide off the sen-
sor mounting bracket and remain in the cam. Remove
the cam and spring from bracket.
9.
Remove the outer spring from the bracket.
10.
Inspect the bushings for excessive wear and replace as
needed.
Remove Handle Shaft Assembly
1.
Remove the top cover. Refer to Remove Top Cover in
this section.
2.
Remove the retaining rings from either side of the han-
dle to access the handle shaft pins. See Figure 15.
3.
Install an M6 capscrew into the threaded end of the
handle shaft pin and remove the pin from the handle
casting.
4.
Lift the handle shaft assembly from the handle casting
and maneuver the link to disconnect it from the throttle
sleeve.
5.
Slide the grips from the shaft. Recover the locking rods
from inside the grips if equipped.
6.
Move the butterfly actuators as required to remove the
spiral pins from the shaft (2 pins per side).
7.
Remove the butterfly actuators from the shaft.
1. BUSHING
2. SHAFT PIN
3. RETAINING RING
4. WASHER
5. LOCKING ROD
6. GRIP
7. ACTUATOR
8. SHIM
9. SPIRAL PIN
10. SHAFT
11. SLEEVE
Figure 15. Handle Shaft
Remove Side Glide Switches
1.
Remove the top cover. See Remove Top Cover in this
section.
NOTE:
Hold the cover when removing the screws.
2.
Remove the two screws and washers holding the Side
Glide switch assembly to the handle. See Figure 16.
3.
Carefully separate the cover, actuator, and spring from
the switch base.
4.
Disconnect the wiring connector from the switch.
5.
Remove the two screws retaining the Side Glide switch
to the switch base and remove the switch.
Control Handle (HD Option)
2200 SRM 1640
16