© 2022 HyQuest Solutions
86
Operation
4.4.3
Charger LED Flash States
The solar regulator charge status can be determined by viewing the red status LED located at the top of the main board.
Figure 22 – Location of solar regulator status LED (Red)
State
One Second
One Second
One Second
One Second
One Second
Sleep
mode
(1mS on)
CC Mode
CV Mode
Not Charging
Table 12 – Shows the solar charge status LED sequence (Measured in 100mS slices, except for sleep where on time is 1ms)
4.5
SMS Communication
The iRIS can send a standard text message in response to a request received via SMS (see Section below). If the call-back
mode is set to SMS a message is also sent if an alarm is activated, a comms scheduler trigger occurs or user initiated
communications test is done.
The SMS message is constructed from the site name, iRIS’s time, plus the sensor name, last logged value, derived values
(min, max, etc.) and units of all the sensors that have their SMS enable flag set.
My Site Name (AG5-0003),03/09/2020:12:34:56:Water Level=7.69m,Battery=12.73,RSSI=-085dBm
If the message was sent because of an alarm event, the message will have the prefix “ALARM!” at the start of
the message.
For more information, see the following subsections:
Summary of Contents for iRIS Under Cover
