© 2022 HyQuest Solutions
18
Configuration
3.2.7.4
Configuration: Measurements
Note
Description
1
Enable/Disable the SDI-12 interface.
Having this disabled will make the device not record any SDI-12 data
2
Clicking on the magnifier will start an SDI-12 device scan. The device will automatically detect any
connected SDI-12 sensors.
§
Once the device scan is started, and you have found all the devices you need, you can click FINISH to
stop the scan and show your sensors.
§
Supported discovered SDI-12 sensors will allow you to perform a quick-setup. Clicking the button will
open a dialog to configure the measurement:
3
Both manually and automatically (supported sensor) added SDI-12 measurements will be displayed here.
Add SDI-12 measurements manually by clicking the + button.
4
Some SDI-12 sensors will require to be powered for some time before being able to perform a
measurement, here the time in seconds between power-on and starting a measurement can be set.
