6
Installation:
Mounting
STEP 1
Use the cardboard drilling template supplied with your Hypervolt to mark out the mounting holes for the back box (B).
Your Hypervolt unit and accompanying holster should be fixed between 0.5m and 1.5m above the ground. We recommend the holster position in the diagram is the
best place for it relative to the Hypervolt's position.
Drill out all 4 fixing holes and fit the top 2 screws (5) leaving them 10mm out. For brick the recommended would be to use a 5.5mm SDS drill, Red plugs & 4x40mm
screws. Hang the Hypervolt on to the top two screws.
Maximum height 1.5m
Minimum height 0.5m
Before removing the LED Plate (B) we recommend first mounting your Hypervolt charger.
Please note the following;
- The mounting site should be flat, away from extreme external influences and close enough to the EV to prevent the tethered cable causing a trip hazard.
- There are many different fixings that can be used depending on the material being fixed to so please provide the ones most appropriate, no fixings are supplied.
- The unit comes with a cardboard mounting template however a metal version can be purchased.
- Pole Mounts are available for purchase should you opt to install your Hypervolt as a freestanding charger.