EDGE Pro and MicroEDGE Pro CNCs
Field Service Bulletin 808280
5
Repositioning SERCOS II and SERCOS III boards in the MicroEDGE Pro CNC
Location of boards in MicroEDGE Pro PCI slots
As you follow this procedure, set aside all screws and other hardware for reuse.
To remove the enclosure cover:
1.
Use a #1 Phillips screwdriver to remove the 6 screws on the top of the panel.
2.
Use a #1 Phillips screwdriver to remove the 2 screws on the side, at the bottom.
To remove the SERCOS II or SERCOS III master board:
1.
Remove the RX and TX cables from the back of the CNC.
2.
Use a #1 Phillips screwdriver to remove the screw that connects the PCI bracket at the side of the board to the
enclosure.
3.
Pull the board from PCI slot 3 on the motherboard.
To reposition the wireless board:
1.
Disconnect the antennas or antenna cables from the connectors on the back of the CNC.
2.
Use a #1 Phillips screwdriver to remove the screw that connects the PCI bracket to the enclosure.
3.
Pull the wireless board from PCI slot 2 on the motherboard.
4.
Insert the PCB connector into PCI slot 3 on the motherboard.
5.
Fasten the screw through the PCI bracket into the enclosure and tighten it to 1.12 N·m (10 lb·in.).
6.
Connect the antennas or antenna cables to the back of the CNC.
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
SE
RCOS
I
I o
r SE
RCOS
I
II m
a
s
te
r b
o
a
rd
U
til
ity/serial isol
atio
n bo
ard
Not used
Not used
W
ireless board
