16
ArcGlide THC Replacement Parts
Field Service Bulletin 806560
2 – Replacing ArcGlide parts
228579 – 230 V surge board
Follow the steps in
Accessing control module parts
or
on page 12 to open the rear panel. Set
aside all screws and other hardware for reuse.
To remove the surge board:
1.
Remove the cables from J1 and J2.
2.
Remove the screws at either end of the board.
3.
Remove the board from the standoffs.
To replace the surge board:
1.
Place the new board over the standoffs and snap it into
place.
2.
Fasten the 2 screws at either end of the board. Tighten the
screws to 1.13 N·m (10 lb·in.).
3.
Replace the cable from the transformer (in the control
module) or line filter (in the HMI) into J1.
4.
Replace the cable from the power supply into J2.
5.
Replace the rear panel of the enclosure and fasten the screws. Tighten the screws to 1.13 N·m (10 lb·in.).
J1
J2
Surge board
