www.hypercable.fr
www.e-rake.fr
9
2-3 Mechanical Description
Please refer to the following table for the meaning of each feature.
ODU: (External antenna)
4GHz 2x2 MIMO HT-OFDM Outdoor Radio Figure
Note:
1. RF1-Primary port connect to V. polarization of the MIMO antenna.
2. RF1-Secondary port connect to H. Polarization of the MIMO antenna.
Note: screw the cap back well after you use the reset button.
This equipment must be grounded. Never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor.
Contact the appropriate electrical inspection authority or an electrician if you
are uncertain that suitable grounding is available.
1
RJ-45 Port – Ethernet 1
Ethernet with DC current by POE, Use the SFTP cat.5 cable with weatherproof
connector to connect to the “To ODU” side of the POE injector.
2
M12 – Ethernet 2
Ethernet Only by Ethernet cable with M12 connector.
3
N- Jack Antenna connector
Here you can attach the N-type external antenna to the 4GHz 2x2 MIMO Radio. In
order to improve the RF signal radiation of your antenna, proper antenna
installation is necessary.
4
RSSI level via LED
RSSI level via LED indicator, more LED represent stronger RSSI.
5
Reset button
Revolve the plastic cap, you will see the reset button. Press it and hold for 5~10
seconds, the radio will back to factory default settings.
6
Grounding stud
Connect to the ground conductor with the ground wire.
7
Membrane Vent
1.
Moisture vapor permeable to help aid in condensation and fogging reduction
in the ODU.
2.
High airflow allows pressure equalization to prevent stress on enclosure seals
Grounding stud
Reset button
Membrane Vent
Grounding stud
RJ-45 Port
(Ethernet 1)
RF1- Primary
RF1- Secondary
LED for RSSI
M12
– Ethernet 2
M12 Cap