HYPERCABLE sarl - 74 Avenue Paul Sabatier ZA de la Coupe 11.100 Narbonne Tel : +33 (0) 4 68 70 91 75 - Fax : 04 68 70 91 76
Mail : [email protected] - N° SIRET : 384 007 894 00031 – Code TVA CEE: FR90384007894 -
www.hypercable.fr
MECHANICAL DESCRIPTION
Please refer to the following table for the meaning of each feature.
Portable/PWS-M-A Subscriber or Base Station Unit Figure
1
Power Input (M12)
Feed 10~30VDC power to the PWS-M-AUnit via this power Jack, please follow the pin
assignment for c / - polarity, mix that might cause the damage of radio.
4
Power LED
Indicate status of power on or off.
2
RSSI LED indicator
This function only works at CPE mode to indicate the RSSI from Base Station, 5 LEDs
(levels) totally, more LEDs means stronger signal level. ( For TDMA PMPT version only )
3
Reset button
press it and hold the reset button for 5~10 seconds, the PWS-M-AUnit will back to
factory default settings.
5
SHF 2.4 GHz N- Jack
Antenna Connector
Here you can attach the proper antenna with the PWS-M-Aunit to wirelessly connect
to the networks. In order to improve the RF signal radiation of your antenna, proper
antenna installation is necessary.(VSWR less than 1.5)
6
LAN Port (M12)
Use the SFTP cat.5 cable with M12 connector to connect to the PWS-M-AUnit, and the
other end to other Ethernet device such as PC or switch / router.
7
UHF 400 MHz N- Jack
Antenna Connector
Here you can attach the proper antenna with the PWS-M-Aunit to wirelessly connect
to the networks. In order to improve the RF signal radiation of your antenna, proper
antenna installation is necessary.(VSWR less than 1.5)
7. UHF 400 MHz N- Jack Antenna
Connector
2.
RSSI LED indicator
6. LAN Port (RJ45)
3. Reset button
1. Power Input (M12)
4. Power LED
5.SHF 2.4 GHz N- Jack Antenna
Connector
