P
A
G
E
20
Handlebar and Stem (Single Bolt)
1.
Assemble the stem to the fork: If necessary, assemble the stem to
bolt (4),washer (5), and wedge nut (2) to the stem (1).
Turn the stem bolt only four revolutions into the wedge nut.
Turn the stem bolt only four revolutions into the wedge nut (2).
Point the stem toward the front of the bicycle and put it into the locknut (7).
Put the stem at a comfortable height for the rider.
WARNING:
To prevent steering system damage and possible loss of
control, the “MIN-IN” (minimum insertion) mark on the stem must
be inside the locknut.
Make sure you can not see the “MIN-IN” (minimum insertion) mark (3) on
the stem above the locknut.
Tighten the stem bolt just enough that the stem will not
fall into the locknut.
2.
Assemble the handlebar to the stem:
Put the handlebar (8) into the stem, but do not tighten the handlebar clamp (6)
at this time.
Align the stem with the front wheel and tighten the stem bolt
3.
Assemble the brake lever to the handlebar. Loosen the clamp screw of each
brake lever.
If necessary, move the handlebar to each side to install the brake levers put the brake levers on the
handlebar with the brake lever for the rear brake on the right side of handlebar.
Do not tighten the clamp screw of the brake levers at this time.
4.
Tighten stem bolt and the handlebar clamp:
WARNING:
do not overtighten the stem bolt. Over tightening the stem bolt can damage the steering
and cause loss of control. Make sure the stem is aligned with the front wheel and tighten stem bolt
MINIMUM
INSERTION
LINE
Single Bolt Stem Diagram
A
D
JU
S
T
M
E
N
T
BICYCLE
ASSEMBLY
Summary of Contents for Scotty Cranmer SC1
Page 1: ...B I C Y C L E O W N E R S M A N U A L ...
Page 34: ...P A G E 32 NOTES ...
Page 43: ...P A G E 41 NOTES ...
Page 44: ...P A G E 42 NOTES ...
