INSTALL PEDALS
1.
2.
NOTE:
Hand thread pedals into position without use of a wrench
to ensure threads are not crossed. Damage to crank arm
will result from crossed threads. When tightening with a
wrench, make sure each spindle is firmly seated against
the crank arm. If jaws of wrench are too thick, they may
prevent proper tightening of pedal spindle against
crank arm.
Thread the pedal marked “R” clockwise into the right or chain
wheel side of the crank arm.
Thread the pedal marked “L” counter-clockwise into the left
side of the crank arm.
All pedals have “L” or “R” stamped on the threaded spindle of
each pedal.
INSTALL SADDLE
1.
NOTE:
Seat post must be inserted at least to the minimum
insertion mark stamped on the lower part of the post. If
no minimum insertion mark can be found, make sure at
least 3” of the post is inside the bicycle frame tube.
Insert the seat post into bicycle frame tube with small
Swaged end up.
2.
3.
4.
Tighten the seat post clamp nut securely. Recommended
torque is 120 in./lbs.
Loosen saddle clamp nut(s) so saddle clamp will fit down fully
onto top swaged end of seat post.
Tighten seat post bolt. Recommended torque is 150 in/lbs.
P
A
G
E
17
INSTALL PEDALS
Side of Pedal
SPINDLE
Right Pedal
turn clockwise
Side of Pedal
SPINDLE
Left Pedal
turn counter clockwise
Left Pedal
Saddle Adjustment
SEAT POST
SEAT POST CLAMP
SADDLE CLAMP BOLT
A
D
JU
S
T
M
E
N
T
BICYCLE
ASSEMBLY
Summary of Contents for Scotty Cranmer SC1
Page 1: ...B I C Y C L E O W N E R S M A N U A L ...
Page 34: ...P A G E 32 NOTES ...
Page 43: ...P A G E 41 NOTES ...
Page 44: ...P A G E 42 NOTES ...
