HYOSUNG Comet 250 FI, Owner'S Manual

Page: 40 / 78

39
1. Inspect every day once before riding
the motorcycle.
2. The transmission is in neutral.
3. The ignition switch is in the “ON”
position.
4. The engine stop switch is in the “ ”
position.
5. Moving the side stand to the fully
upper position.
6. Push the starter switch without turning
the throttle grip after go out the “FI”
check lamp .
RIDING TIPS
STARTING THE ENGINE
Before attempting to
start the engine make
sure :
9. Operate the engine a few minutes by
idling speed.
Inspect to leak oil at the oil filter cap.
10. Confirm the oil level with the oil level
lens after waiting about a minute next to
stopping the engine.
The oil level is located between the
“Lower line (L)” and the “Upper line (F)”.
When below the “Lower line (L)”, refill
the oil between the “Lower line (L)” and
the “Upper line (F)”.
In case of the engine oil pouring
excessively, the engine output being
made insufficient.
Be careful not to pour engine oil.
CAUTION
The are equipped
with the side stand ignition interlock
system.
1. If the transmission is in neutral, you
can start the engine regardless of
clutch lever and side stand.
2. If the transmission is not in neutral,
you can only start the engine with
pulling in clutch lever and side stand
up.
Make sure that the side stand igintion
interlock system is working properly
before riding.
WARNING
always come on the
position lamp, meter lamp, tail lamp and
license plate lamp when starting the
engine.
CAUTION
GT250‡»` 2008.7.18 4:12 PM ˘ ` 39 JINSUN 300DPI 100LPI W