EN © HYKKER.
All rights reserved.
Soundbar 2in1
23
previously prepared in the wall. Check that it hangs securely and correct the screwing
level if necessary.
Option C
Fix the stands on the columns and connect them with a long connecting cable. Place
the columns on the sides of the TV and connect the cable that will connect them to the
sound source and power supply.
Option D
Choose where to mount the columns on the wall on the sides of the TV. The
recommended distance from the side edges of the TV is about 5 cm. Mark the location
of the holes in the selected mounting positions on the wall. Make sure that they are at
the same level, then drill holes and place dowels in them. Slide the screws into the
dowels and tighten them so that they are approx. 3 mm from the wall. Connect the
loudspeakers to each other with a long connecting cable, then connect the cable that
will connect them to the sound source and the power supply and fasten them on the
pre-prepared dowels in the wall. Check that they hang securely and correct the
screwing level if necessary.
SWITCHING THE DEVICE ON/OFF AND SELECTION OF OPERATING MODES
Press the on/off button for 2 seconds to start the device. Pressing the button again for
2 seconds will switch the device off.
Press briefly the same button to select the operating mode of the device. The individual
modes are indicated by the LED of a given colour:
•
Blue - Bluetooth connection
•
Green - line input (AUX IN)
•
Orange (blinking)
–
digital HDMI ARC input
•
Orange - digital optical input
•
Green (blinking) -USB input
The Soundbar by default activates the last used mode.
If the AC adapter is
disconnected from the device, if the adapter is unplugged from the electrical outlet or
if there is a power outage in the mains, the Bluetooth connection mode is activated by
default.
CONNECTING TO SOUND SOURCES - WIRED ANALOGUE
1.
Connect the soundbar to the sound source using the supplied minijack-
minijack cable. If necessary, a mini-RCA adapter (included) can also be used if
the audio output is equipped with RCA connectors (so-called cinch) in the
audio source.
2.
Turn on the soundbar with the button on the side panel or with the remote
control. The remote control must face the infrared receiver of the device (the
right part of the front of the device behind the masking net).
3.
Operation of the line input mode (AUX IN) is indicated by a green LED. If the
LED of a different colour is on, switch the unit's operating mode to line input.
4.
The control of the sound (e.g. changing or rewinding songs) in this mode of
