8075A_B.docx
10
February 2017
Monitor Disassembly
To access the serviceable parts inside the monitor, the 8075A
panel must be removed from the carrying case.
WARNING: Unplug the 8075A from power before disassembly.
Even with the power switch off, voltages are present inside the
unit.
Use a screwdriver to remove the 5 screws along the perimeter
of the panel holding it in the case. Grab the sample air inlet
elbow to help lift the panel straight up and out of the case.
When re-assembling the panel into the case, make sure sensor
cable wires are tucked in and not pinched under the panel as
you lower it into the case.
Install the 5 mounting screws, taking care not to cross thread
the screws as you proceed. The screws only need to be snug to
the panel, do not overtighten!
