12
ADDON SERIES - SYSTEM ASSEMBLY AND ACTIVATION PROCEDURES
PREPARATION – INSPECT ALL PARTS
NOTE: Read Mounting Bracket and System Plumbing
Installation instructions on Page 1 and all
instructions on this page
before installing system.
ADDON SERIES
Addon Ultraviolet System
Ultraviolet Lamp (in packing tube,
#10
or
#20
varies with model)
Mounting Screws (2 pieces)
Warranty Card (please fill out and return)
Installation Guide and Owners Manual
NOTE:
See Page 13 for Addon detailed parts breakdown.
DISINFECT SYSTEM
CAUTION: QUARTZ SLEEVE IS VERY FRAGILE!
For safety, wear a protective glove when
handling quartz sleeve. Do not touch quartz
sleeve or UV lamp with bare hands. Fingerprints
will reduce effectiveness of the light.
NOTE:
Quartz sleeve is factory installed.
NOTE:
All Items refer to Figure 8.
CAUTION:
TIGHTEN COLLAR BY HAND ONLY. Do not
use tools as they will over-tighten and may
damage sump. Take care not to cut or pinch
Addon Sump Gasket (Item 2).
1. Remove Collar (Item 15) from UV Head (Item 5).
NOTE:
Wipe all fingerprints and excessive lubricant from
quartz sleeve with isopropyl alcohol.
2. Disinfect the system (Pages 14-15, Steps 1-7).
INSTALL ULTRAVIOLET LIGHT
CAUTION: DO NOT INSTALL A DAMAGED LAMP
NOTE:
Hold UV lamp by ceramic ends only.
Do not touch the glass. Clean glass with
isopropyl alcohol if necessary.
1. Remove the UV Lamp (Item 16 or 16A) from packing tube
and inspect it for damage. If damage is found, contact the
dealer for a replacement.
2. Connect UV lamp into the four-pin socket that is
connected to the UV Control (Item 10).
3. Carefully insert the UV lamp through “O” Ring Retainer
(Item 11) into the quartz sleeve as far as possible.
NOTE:
End of UV lamp will touch the bottom of
quartz sleeve.
4. Slide Finish Cap (Item 12) on UV control cable and snap
finish cap into “O” Ring Retainer (Item 11).
ACTIVATE SYSTEM
CAUTION:
Verify that inlet and outlet ports are connected to
appropriate inlet/outlet pipes (see Figure 8).
WARNING:
NEVER LOOK DIRECTLY AT A LIGHTED UV
LAMP. ALWAYS LOOK AT LAMP THROUGH
FINISH CAP ONLY.
1. Plug system into an electrical outlet. The finish cap should
illuminate within one minute, indicating UV lamp is on. If it
does not, unplug system, verify the UV lamp is securely
plugged into four-pin socket, and repeat this Step.
NOTE:
UV lamp should remain on at all times during use
because; repeated starting of UV lamp shortens
lamp life, and UV lamp requires a warm up period
of 1-2 minutes.
2. Turn on water supply and check for leaks.
3. Flush system, connectors, and water lines for several
minutes to remove carbon fines.
NOTE:
When an ultraviolet water treatment system is unused
for several hours, water within system could become
warm. This is a normal condition. To cool the water,
dispense water from system.
NOTE:
System is now ready for use.
Service Requirements
Recommended Service Intervals
To ensure the system operates at its optimum level, certain routine
maintenance must be performed. Frequency of maintenance performance
will depend on source water quality and level of system usage.
CLEAN:
Every 3 to 6 months
DISINFECT:
At least once a year
UV lamp #10 or #20:
Change Annually
Quartz Sleeve #11 or #20:
Clean when changing lamp. Replace only if
damaged or cannot be cleaned by non-abrasive methods.