5
Hydro
Tab
Marine Engineering
A good hint is that the closer the units are to the water line, the best the bank control of the boat will be
(Figure 3).
Attention!
Please make sure that the pipe
insertion hole is accessible from the engine room
(Figure 2).
Make sure there are no obstructions behind the
drilling area (tanks, fuel lines, cabling) which can
be damaged or prevent the installation (Figure 1).
1. For high speed boats, overtrim may cause unexpectable turn. Improper use of trim tabs, may result to
accident or injury.
2. DO NOT PLACE YOUR FINGERS INSIDE THE INTERCEPTOR, through the front holes (Figure 4).
Severe injury danger!!!
Before Installation
2
1
3
Right
Wrong
Drill Ø4
Drill Ø8,5
Drill Ø5.5
Hole Saw Ø70
Drill Ø3
5mm
Allen Key No 5
Screwdriver
Drilling tool
Marking tool
(pencil or marker)
Sikaflex gun
Safety precautions
WARNING!
4
Required Tools for Installation
If there is a double installation on the boat please
allow a 18 to 20 mm space between them (Figure
4).