HYDROSCAND AutoCal H24D, User Manual

Page: 12 / 44

H24/H32D AutoCal USER MAnUAL EDiTiOn i 2013-02-27
12
Die Set Die Set Crimping area Crimping area
20-10
20-12
20-14
20-16
20-19
20-23
20-27
20-31
20-36
20-41
20-47
20-54 10-12 mm
12-14 mm
14-16 mm
16-19 mm
19-23 mm
23-27 mm
27-31 mm
31-36 mm
36-41 mm
41-47 mm
47-54 mm
54-61 mm 32-10
32-12
32-14
32-16
32-19
32-22
32-26
32-30
32-34
32-39
32-45
32-51
32-57
32-63
32-69
32-74
32-78 10-12 mm
12-14 mm
14-16 mm
16-19 mm
19-22 mm
22-26 mm
26-30 mm
30-34 mm
34-39 mm
39-45 mm
45-51 mm
51-57 mm
57-63 mm
63-69 mm
69-74 mm
74-78 mm
78-87 mm
H24 DIes H32 DIes
4.6 Changing individual die segments
place the machine on a stable and flat surface. Adjust the machine’s feet so that they cannot
be over-turned or fall from the surface. if the optional die stand is used, the machine must be
bolted to the Die stand and the stand bolted to the floor.
1. Retract the dies completely by pressing the return button twice (2).
The machine stops at the first button push at the set opening diameter.
2. Remove a die segment by using the included tool and pull the die set pin
until the die releases.
3. Make sure the 8-segment die set is clean, undamaged and that all die seg -
ments are the same size with the die size markings facing towards you.
insert the dies from the front. Mount the die segment by pulling the die set pin
with the qC-tool, insert the die set pin in the hole in the master die and release
the locking pin with the qC-tool.
4. Ensure that all die segments are correctly inserted in the machine.