Operating considerations for BES with Remote Control Auto Fill/Drain (option D):
1. Insure that SYSTEM INTERFACE MODULE (DRAIN/FILL CONTROL) option is
securely plugged into BES receptacle and that Auto-Drain valve cord is installed.
Install one set of air tubing and air button from Remote Control on the On/Off air
BES and Remote Control are set to minimum (fully CCW).
If
y.
ay require
se until the heat light on the Remote
applied.
. Once temp is reached the fill light will again appear, heat light will be off and the
7.
temp display will be blank. Pump will stop.
. Once the tub is empty press On/Off until all indicators are off to insure no inadvertent
n is selected you must allow drain valve to travel completely
before switching back or the unit may stick half way requiring power to be recycled***
Hea r Pressure Switch adjustment:
per
g (if air present open pump bleed valve on face to let air escape).
sure switch knob an additional
½ turn CCW.
urn OFF power and remove pump output wire (black or white wire) from back of pump
otor and insure it is isolated before re-energizing power. Insure that heat indicator does
not come on with the thermostat turned up. If indicator does illuminate immediately
disconnect power, reconnect pump, and repeat steps 1-3.
switch nipple and one set on the Fill/Drain air switch nipple.
2. Insure Remote Control is plugged into receptacle from option control and that both
thermostats on
3. Apply power and if no lights appear on Remote Control press On/Off button once.
drain light illuminates wait for valve to finish rotating and then press Fill/Drain button
once. If fill light is lit allow unit to fill normall
4. The unit is full once the digital display appears on Remote Control. Pump will engage
and the unit should be ready to heat once air is purged (pressure switch m
adjustment).
5. Turn the Remote Control thermostat clockwi
Control engages and set dial for desired temperature. The pump will continue to run
as long as tub is full and power is
6
digital display will display actual temperature. Pump will continue to run.
To drain press Fill/Drain once. Indicators should switch from fill or heat to drain and
8
filling or draining can take place.
***Once Fill or Drai
te
With pump running and thermostat calling for heat if no heat indicator is illuminated
form the following:
1. Insure flow is moving into tub from equipment and that no air bubbles are present at
tub return fittin
2. Insert flat tip screwdriver into slot on top of pressure switch and adjust CCW until
heat engages (if heat indicator flickers continue adjusting until it remains steady).
3. Once heat indicator remains on steadily adjust the pres
T
m
85-0130 REV.10
5/11
17
Summary of Contents for BES6000-HC Series
