Hydropool HS4300, Owner'S Manual

Page: 27 / 40

27
·
Never pre - mix chemicals with each other prior to adding to hot tub water.
·
Add only one chemical to the water at a me.
·
Always add chemicals to water and not vice - versa.
·
Chemicals may be corrosive, so handle with care and store in a cool dark place.
· Never smoke near chemicals as most are flammable
·
Ensure any spilled chemicals are carefully cleaned up immediately.
·
Always have the POISON CONTROL telephone number handy in the event of an emergency.
·
Keep chemicals out of children‘s reach
·
Wear safety glasses and gloves when handling chemicals.
CHEMICAL HANDLING SAFETY HINTS
1. Make sure the hot tub water is circula ng and above 20°C (68°F)
2. Add a sequesterant (stain and scale controller). Allow water to circulate for an hour before adding anything
else to the hot tub water.
3. Add a Shock / oxidizing agent .
4. Add sani zing tablets (Bromine or Chlorine) to the dispenser:
Built in dispenser : if your Hydropool hot tub was ordered with the op onal built in bromine/chlorine dispenser,
(located under the basket of the cartridge filter housing), refer to sec on CARTRIDGE FILTER for details on
removing and re - installing the lid. Once the filter lid is removed, you’ll no ce a clear 2.5 cm (1 in.) tube
extending from the bo om of the basket. Expose the large Refill hole at the end of the tube and add 5 or 6
tablets. Do not overfill dispenser as performance will be affected. Turn to expose the most number of smaller
holes and allow water to circulate for 3 to 4 hours before tes ng level. Adjust to lesser number of holes as
necessary to maintain a level of 2
- 4 PPM Sani zer.
Floa ng dispenser : As above, add 6 or 7 tablets, adjust ini ally to ‘5’, allow water to circulate for 3 to 4 hours,
then test. The tablets will dissolve slowly over a 10 - 14 day period, depending on dial se ng, and use of the hot
tub.
5. Test pH and Total Alkalinity and adjust accordingly.
WARNING
INITIAL WATER FILL AND BALANCE