Hydromatic HPGLX200 Installation And Service Manual Download Page 12

Item # E-03-438  3M  3/02

Part #  5625-438-1

WARRANTY

Hydromatic  Pumps,  Inc.  warrants  to  the  original  purchaser  of  each  Hydromatic  product(s)  that  any  part

thereof which proves to be defective in material or workmanship within one year from date of installation or
18  months  from  manufacture  date,  whichever  comes  first,  will  be  replaced  at  no  charge  with  a  new  or 
remanufactured  part,  F.O.B.  factory.  Purchaser  shall  assume  all  responsibility  and  expense  from  removal, 
reinstallation  and  freight. Any  item(s)  designated  as  manufactured  by  others  shall  be  covered  only  by  the 
express  warranty  of  the  manufacturer  thereof.  This  warranty  does  not  apply  to  damage  resulting  from
accident,  alteration,  design,  misuse  or  abuse.  The  pump  must  be  installed,  operated  and  maintained  in 
accordance with the published instructions of the appropriate Installation & Service Manual.

All dual seal non-clogs and 2 HP grinders must have seal failure and heat sensors attached and functional

for Warranty to be in effect. If a seal failure should occur, Hydromatic Pumps will cover only the lower seal
and labor thereof. Labor based on Authorized Service Center contract allowance. If the heat sensor is not
attached and functional, Warranty is void. If the seal failure sensor is not attached and functional, Warranty
is void.

If the material furnished to the Buyer shall fail to conform to this contract or to any of the terms of this 

written warranty, Hydromatic Pumps, Inc. shall replace such nonconforming material at the original point
of  delivery  and  shall  furnish  instruction  for  its  disposition.  Any  transportation  charges  involved  in  such
disposition shall be for the Buyer’s account. The Buyer’s exclusive and sole remedy on account or in respect
of the furnishing of material that does not conform to this contract or to this written warranty, shall be to 
secure replacement thereof as aforesaid. Hydromatic Pumps, Inc. shall not in any event be liable for the cost
of any labor expended on any such material or for any incidental or consequential damages to anyone by
reason of the fact that such material does not conform to this contract or to this written warranty.

ALL IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY

AND THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE DISCLAIMED
TO THE SAME EXTENT AS THE EXPRESS WARRANTY CONTAINED HEREIN. Some states do not
allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.

MANUFACTURER  EXPRESSLY DISCLAIMS  AND  EXCLUDES  ANY LIABILITY FOR 

CONSEQUENTIAL OR  INCIDENTAL DAMAGES  FOR  BREACH  OF ANY EXPRESS  OR  IMPLIED
WARRANTY ARISING  IN  CONNECTION  WITH  THIS  PRODUCT,  INCLUDING  WITHOUT
LIMITATION,  WHETHER  IN  TORT,  NEGLIGENCE,  STRICT LIABILITY CONTRACT OR 
OTHERWISE. Some States do not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and
you may also have other rights which vary from State to State.

© 2001 Hydromatic

®

Ashland, Ohio.  All Rights Reserved.

– Your Authorized Local Distributor –

USA

1840 Baney Road Ashland, Ohio 44805

Tel: 419-289-3042  Fax: 419-281-4087

www.hydromatic.com

ISO 9001 Registered Quality System

CANADA

269 Trillium Drive Kitchener, Ontario, Canada N2G 4W5

Tel: 519-896-2163  Fax: 519-896-6337

Summary of Contents for HPGLX200













Reviews: