66
STEP 6:
Install the Support Leg/Housing Wrench,
as shown.
STEP 8:
Install blue purified water tubing and black
wastewater tubing into corresponding elbow
connector fittings as shown. The in-line shut-off
valve should only be installed on the blue purified
water line to shut system off/on.
STEP 7:
Install the white inlet tubing by pushing the tubing
into pressure gauge fitting. Push the garden
STEP 9:
Apply a thin layer of lube to both o-rings on
the two membranes. Carefully push the first
membrane into the position shown in STEP
10. Push it straight down into the hole of the
manifold until both o-rings are seated in the
hole. Install housing over membrane.
Do not
rock membrane back and forth to
install.
Repeat this step
for second membrane.
hose inlet fitting onto other end of
tubing. This fitting is compatible
with garden hoses and hose
bibs.
STEP 5:
Install the pressure gauge assembly. Push the
short length of tubing into the left side of the
gauge. Push the other end of the tubing into
the elbow connector fitting as shown.
Apply lube here
Shut-off
Valve
STEP 10:
Once the two membranes are properly seated,
re-install housings and
tubing. Run system for two
minutes to check for leaks.
If leaking, use the wrench
to tighten the housings, one
clockwise quarter-turn.
Reminder:
Anytime you
change the carbon filter, it
must be flushed
without
membranes
for at least 10
minutes.
Flush for TEN MINUTES. Once
properly flushed, remove tubing
and use wrench to remove the
two EMPTY membrane housings.
INCLUDES
