14 | www.HydroBikes.com
ASSEMBLE YOUR HYDROBIKE
®
STEP 7:
Install the prop assembly
Next up is installing the prop assembly into position. With one hand
securing the prop assembly, reach down and loosen the black locking bolt
near the rear hub
(A)
before lowering the prop arm to an approximate
forty-five-degree angle
(B)
. Re-secure the locking bolt with light force.
Over
tightening this bolt could damage the locking bolt
.
Locate the lever arm bracket on the side of the drivetrain
(C)
. To insert the
lever into the bracket, depress the two silver buttons and slide in slowly
until the buttons lock into the bracket. Test the lever’s effectiveness by
raising and lowering the drive unit.
For transport, press the prop lever down in a forward position, securing it
in the left pedal strap.
STEP 8:
Install the seat
Insert the wide end of the seat post into the bike frame and adjust to a
suitable height
(A)
.
To tighten the seat post clamp, hold the bolt head with your hand or a
pair of pliers while turning the lever side in a clockwise direction for two
to three revolutions
(B)
. With your thumb, fold the lever downward. If the
lever moves with too little pressure or resistance, tighten slightly until the
lever securely holds the seat post. Make sure the lever is pointed down
when tightened and flush with the bike frame.
Next, fit the seat onto the end of the seat post and adjust to a level
position. Secure the nut with an adjustable wrench or pliers
(C)
.
