HydraMaster Truckmount to Go TMTG 4000, Owner'S Manual

Page: 35 / 124

3-9: Cleaning Information
RX20 NEXT GEN Tool for Carpet, Hard Surface and Bonnet Cleaning
Before turning on the RX20 NEXT GEN, adjust the handle; it should rest right below or
even with the bottom of your pants’ front pockets, with the tool resting flat on the floor.
Take your time in adjusting the tool’s height; make sure the head of the tool is flat with the
floor while you are holding the handle. Relax your posture; the more difficult it is to hold
the tool’s head flat on the floor surface, the more quickly you will tire.
As with the wand, drying times will be improved if you run a dry pass between wet passes.
Hold down the solution trigger and move the unit left or right across the floor 3 or 4 ft.,
then immediately back across the same pass, without the solution flowing, to make the
dry pass. Make the next pass half-overlapping the previous pass.
Use the RX20 NEXT GEN in very heavily trafficked areas or if it has been a long time
since the carpet has been cleaned. Beware of the seam edges of carpets and transition
edges between floor surfaces. Use extreme caution when cleaning these areas.
Sometimes it is necessary to use an edge tool or wand to outline the perimeter of the
room in difficult-to-reach areas where the circular head of the rotary units will not reach.
The 5 vacuum heads and 3 jets
rotate at 130 rpm, creating
650 complete cleaning
passes per minute.
For Truckmount or Portable
Carpet Cleaning Systems
• Aggressive restorative extractor tool
for carpet, hard surface and bonnet
cleaning
• Labor-saving, ergonomic design
• Superior agitation for cleaning
stains, heavily soiled and
matted carpet
• Durable construction for long
life
• Reduces fatigue of the
operator