HydraMaster Corporation
1/25/00
DriMaster Upholstery Tool Page 1
Getting Started
To Begin Cleaning:
1. Attach the solution hose to the
Solution Quick Connect
. A 1-
2
or 2 vacuum hose can be attached
to the
Vac Hose Manifold
.
2. Adjust the water volume by turning
the
Needle Valve
knob. By turning
the knob counterclockwise, the
water volume will increase. By
turning the knob clockwise the
water volume will decrease. The
amount of water volume you need
will vary with the type of machine
you are cleaning with.
To Adjust Water Volume Using the Needle Valve Knob:
A. Close the
Needle Valve
.
B. While the machine is running, turn the
Solution Valve
to the ON position.
C. Slowly open the
Needle Valve
until water is flowing across the entire
injector bar (without overspray).
Note:
The amount of vacuum and
pressure produced by your machine
will determine the overspray on the
Solution Injector Bar
.
3. The
Solution Valve
is only an ON/
OFF valve; the patented
Solution
Injector Bar
makes a trigger valve
unnecessary.
To turn the water ON, the
Solution
Valve
on the upholstery tool head
needs to be turned clockwise. Let the water run continuously for a few minutes to
allow the hot water to reach the upholstery tool.
