© Hydra-Flex, Inc. 2017
OVERVIEW
Page | 1
FEATURES
•
Consistent and accurate chemical application
•
Flexible pump design—flow rates FROM 10 to 40 GPM
•
Compact design reduces footprint
•
Pre-wired and pre-plumbed for fast installation
•
Easy Plug-and-Play utility and chemical connections
•
Modular design—customized to your needs for up to 15 chemicals plus Tri-Foam
•
Uses Hydra-Cannon Chemical Manifold Systems for easy and quick service
•
Color-coded Chem-Flex Injectors using Quick-Change connections
•
For new installations or retrofit in any car wash
The AQUA-LAB will simplify the delivery of liquid chemicals to your car wash arch. Its plug-and play
system is compact and pre-assembled for quick installation.
To ensure that the AQUA-LAB will interface properly with your car wash facility, you must first verify that
your facility has all of the proper space and connection requirements according to the specifications
below. You must also verify that you have ordered the proper part number for your AQUA-LAB to match
the requirements needed by your facility.
SPECIFICATIONS
•
UP to 15 Chemical Ports
•
Up to 15 Pneumatic Ports
•
Hydraulics operating pressure: 200 psi (Factory set)
•
Pneumatics operating pressure: 100 psi (Factory set)
•
Operating Ambient Temperature: 40-120 Deg F
•
Operate pumps with 208/230 or 480 Voltages (3-phase)
•
Operate Solenoid Valves with 24VAC, 24VDC, 120VAC
•
1-1/2” water supply line (TX Model)
•
1” water supply line (AX & BX Models)
•
Inlet pressure: 2-80 psi
•
Space Requirements:
a. Aqua Lab Systems
i. TXF Model – 3’ x 3’ footprint with 5’ Clearance
ii. TXW Model – 2’ wide x 4.5’ high of wall space for system
iii. AX Model – 3’ wide x 2’ high of wall space for system
iv. BX Model – 1.5’ wide x 2’ high of wall space for system
b. Pump Assemblies – Pumps need to be within 3’ of the system to allow connection of the
two with just the included connection hose
i. Single Pump – 4’ x 1’ wall space
ii. Dual Pump Wall mount – 4’ x 3’ of wall space
iii. Dual Pump Floor skid – 4’ wide x 1.5’ deep footprint with 4’ of Clearance
c. Electrical Enclosures
i. Motor Starter (AX and BX Models) – 1’ wide x 1.5’ high of wall space
ii. VFD Motor Controller – 1.5’ wide x 2’ high of wall space
iii. Terminal Box (Accessory) – 1’ wide x 1’ high of wall space
