2.3
MODE CONTROLS
SERVICE MODE
The SERVICE MODE allows the user to adjust the various PLC parameters. The user
will be prompted for a password. Contact Hyd-Mech Group Limited to access this mode.
MANUAL MODE
Pressing this key will enable all of the “MANUAL MODE ONLY CONTROLS.”
AUTO MODE
Pressing this key will disable all of the “MANUAL MODE ONLY CONTROLS.” To enter
AUTO MODE, the FIXED VISE must be activated.
MACHINE & CYCLE CONTROLS
MACHINE START
Pressing this key will activate the control panel, display, and start the hydraulic system.
The EMERGENCY STOP button must be pulled out. This key must be activated to use
the machine functions.
MACHINE STOP
Pressing this key will shut down all machine functions including the control display and
hydraulic system. The display will not have a back light on. All jobs will remain in memory
as will the QUEUE.
CYCLE START
The user will be prompted by the display to press this key as it is used to initiate an AUTO
or SINGLE CUT MODE cycle. Pressing this button will also initiate the QUEUE if pressed
when in the QUEUE screen.
CYCLE PAUSE
Pressing this key will pause the cycle in progress. To resume the cycle, press the CYCLE
START key.
PLC CONTROL SYSTEM
The PLC operator interface occupies the upper left corner of the console, and is used in all four operating modes:
. Manual Mode – permits the operator to control all machine functions using the pushbuttons, as well as the opera-
tor interface function keys.
2. Single Cut Mode – permits the operator to enter part length, and then advance and cut a single part automatically.
3. Automatic Job Mode – is used to automatically cut a ‘job’ (a preset quantity of identical parts).
4. Automatic Que Modes – there are two alternative Que Modes, selectable by changing a PLC parameter.
•
Automatic Queue Mode – is the standard queue mode. It is used to automatically cut up to five different
jobs, consecutively, from a single workpiece or bundle. When all jobs in the queue are completed the saw
shuts down.
•
Multi Queue Mode – is used to repeat the same queue a preset number of times. This mode is primarily
used to cut parts in sets. To illustrate, consider cutting four pieces each, of three different parts, A, B, and
C. In the Auto Que approach, each job is programmed with required quantity of 4. In multi Que approach,
each job only has a quantity of , but the que required is set to 4.
Auto Que
A
A
A
A
B
B
B
B
C
C
C
C
Multi Que
A
B
C
A
B
C
A
B
C
A
B
C
The same number of parts are cut, but Multi Queue procedures the parts in sets, and the first complete set is available
much sooner if large quantities are being cut.
Summary of Contents for H10A
