4.3 Selecting a pre-loaded schedule
The heater is supplied with a number of pre-loaded operating schedules already stored in
memory. It will be quicker to choose one of these defaults if it corresponds sufficiently closely
to your requirements, but you can create your own schedule if you wish (see ‘Programming
your own customised schedule’).
The pre-loaded schedules are identified by a two letter code (e.g. “P3” or “CF”) and are as
follows:
Table of Pre-loaded Operating Schedules
NOTE:
1. The number 0,8,16 and 24 represent time on a 24-hour clock and equates to midnight,
8:00am, 4:00pm and midnight respectively.
2. The “ symbol means the heater operates in OFF PEAK MODE during the given time.
3. The i symbol means the heater operates in PEAK MODE during the given time.
4.
CF
means FROST PROTECTION MODE; the unit will heat only to avoid frost and protect
it when the room temperature is very low.
The temperature cannot be adjusted in this
programme.
5.
CE
means OFF PEAK MODE all the time.
6.
CC
means PEAK MODE all the time. This is the factory default setting.
7.
UP
means USER PROGRAMME; the user can set the programme according to his/her
specific needs.
The UP programme factory default
is PEAK MODE
all day, every day.
10
