14/16
www.hybryd.eu
9. In the case of CT type luminaires connect the communication plug
to the communication socket in main luminaire body.
10. Connect the power supply plug to the emergency module power
supply connector. Connect the mounting part PE connector socket
to the main body PE plug.
11. Put the two parts together along the hinge snap and close the
luminaire by rotating the main body. Please check for the power
supply cables during this operation.
12. Using two metal screws gently screw the two luminaire parts
together.
6. Mark the operating mode on the luminaire label. Mark 0 for the
maintained mode and 1 for the non-maintained mode.
M
NM
7. Remove the light source protecting cardboard before installing
the lampshade.
Mount the exit sign plate in the main luminaire body if it isn’t mounted.
Place the fixing pins in plate holes. Slot the plate into the main part
of the luminaire guide. Use a 1.5mm Allen key (hex key) to screw
fastening bolt a plate.
A lampshade with a safety sign may be mounted later, however, the
light source protecting cardboard must remain in the luminaire.
8. Connect the battery plug to the battery socket on the emergency
module.