5A
A. Universal DMX controller
The fixture can be set the DMX address remotely by universal DMX controller. First, you
need to programming two scenes into a chase, and then link the fixtures to the universal
DMX controller. When you run the chase, all the fixtures of the chain will be set the series
DMX address automatically. The fixture uses four channels. Please refer to the following
diagram to set the address for the first four units.
B. Master/Slave operation
The fixture will allow you to link 16 fixtures together and operate without a controller. In
Master/Slave mode, the first fixture will control the others to give an automatic, sound
activated, synchronized light show. This function is good when you want an instant show.
The first fixture it’s DMX input cable will have nothing connect it, and the other fixtures will
be set in slave mode automatically. Their DMX input cables connect the last fixture DMX
output cable (daisy chain). Any fixture can act as a Master or as a Slave
C. IR remote control
(1)Auto
Chase mode 0 (Chase 1~15 cycle running)
(2)Sound
Sound active (to select sound mode 0~12,also by “+” ,”-” to select)
(3) DMX
DMX address.(pressing this button about 2s, address=001)
(4) Black Out
Switch
(5)Red
Red light is turned on
(6)Green
Green light is turned on
(7)Blue
Blue light is turned on
(8)White
Amber light is turned on
(9) +
Increase chase run speed,DMX address,sound mode,strobe speed
(10)
－
decrease chase run speed,DMX address,sound mode,strobe speed
(11) 0~9
To select sound and chase mode with these button correspondence.
Note:In Jump mode, “0” is the chase mode 10.
(12) Jump
To select chase 1~12.
(13) Fade
To select 3 kinds of gradual mode.
(14) Color
To select red,green,blue,amber
(15)Flash
Strobe switch.(only effectivity in Auto,Jump,color,RGBA)
NOTE:
In DMX mode,the IR remote controller take action until pulling down all handspike for
prevent interference.Then,you can by pressing down “+”,”-”at long time,to increase or
