Attaching Capacitors to Coil Assembly
Loosely assemble two pairs of 1 1/8" x 1"
clamps and two pairs of 1 1/8" x 7/16" clamps
as shown in Details A and B of Figure 6.
Select the 17/20 meter coil assembly (Item 12)
and attach the capacitors onto the coil
assembly using the clamps as shown in Figure
6. Dimensions G, and F will be set later on in
the instructions.
NOTE: The edge of each 11/8" x 1" clamp
should be flush with the bottom edge of each
coil form. The rain caps should be pushed
completely on each 1" tube, and should be
flush with the 11/8" x 7/16" clamp. Tighten the
hardware on these 4 pairs of clamps. Push the
ca
Place a large # 16 tubing clamp (Item 23) over
the slotted end (top) of this assembly, but, DO
NOT tighten at this time.
Detail A
11/8" x 7/16" Mast/Capacitor Clamp
26
Detail B
1 1/8"x 1" Mast/Capacitor Clamp
Figure 6
17/20 Meter Trap Assembly
