IP Relay – 2x relay + RS-232 / Ethernet converter
HW group
June 2006
www.HW-group.com
Page 19 / 28
Description of configuration parameters
In this chapter you can find the detailed description of all possible configuration parameters.
Information on the device configuration can be found in the chapter “QUICK Setup of the device”.
Default device configuration
This is the listing of a standard configuration of every supplied IP Relay. This can be refreshed
anytime by
“
D0” or “D1”commands in the setup mode.
Description of the device configuration and
commands entry can be found in the chapter “Setting other parameters of the device”.
*** HW-group.com HW 6.0 SW 2.M #01 ***
MAC Address 00:0A:59:00:99:3A
=========== IP Setup ============
I: Address 192.168.6.200
J: Port 23
M: Mask 255.255.255.0
G: Gateway 192.168.6.254
===== In IP access filter ======
W: Address 0.0.0.0
N: Mask 0.0.0.0
X: Port 0.0
Y: Port Mask 0.0
== Active (Client/Server) mode ==
S: Send to IP PASSIVE mode
U: Port 23
T: IP mode TCP
V: NetworkVirtualTerminal On
K: Keep connection Off
E: Erase buffer on None
========= Serial Setup ==========
&B: Speed 9600
&D: Data bits 8
&P: Parity NONE
&V: Variable Parity Off
&S: Stop bits 1
&C: Flow Control NONE
&R: RS485/RS422 control RTS = On [+8V]
&T: Serial Line Timeout 0 - Off
&G: Char. Transmit Delay 0 - Off
&H: Tx Control Tx FULL duplex
======== Security Setup =========
%A: TCP autorisation Off
%K: TEA key 0:01:02:03:04 1:05:06:07:08 2:09:0A:0B:0C 3:0D:0E:0F:10
%S: TCP/IP setup On
======= I/O Control Setup =======
#T: Trigger AND mask 255
#A: Power Up INIT 189
#B: Power Up AND mask 255
#C: Power Up OR mask 0
#D: Power Up XOR mask 0
#X: KEEP mask 0
#Y: AND mask 255
#Z: OR mask 0
#W: XOR mask 0
============ Other ============
D: Load/Save Settings from/to Flash
R: Reboot
