IP Relay – 2x relay + RS-232 / Ethernet converter
HW group
June 2006
www.HW-group.com
Page 14 / 28
SETUP using the RS-232 terminal
The description of the configuration using
the supplied software Hercules Setup
Utility. If you cannot use this software, the
device can be set from any RS-232
terminal.
Disconnect the power supply adaptor from
the device.
Set DIP1 = ON, DIP2 = OFF, DIP3 =
OFF, DIP4 = OFF.
Connect the device with supplied RS-232
cable to a PC. Use the Port 1 (DB9F) on
the IP Relay.
Switch to the “Serial” tab of the Hercules
Setup Utility.
1) Set the proper serial port and
communication parameters -
9600
8N1
.
2) Click on the „Open“ button.
Connect the power adaptor into the
feeding connector of the IP Relay. The
green Power indicator should light up.
The listing of configuration parameters will
appear in the „Received/Sent data“
window.
Concrete parameter is set by choosing the
letter corresponding to the desired option
and its value. (for example „I192.168.6.8“
for IP address of the device).
Note:
Complete listing of the configuration
parameters and commands with detailed
description can be found in the chapter
“description of the configuration
parameters”
You can see help to any command when
you send the commands name together
with the question mark (for example „
I?
<Enter>
“.
After you set all the desired parameters,
call the
“R”
function (
Reboot
).
Close the serial connection with using the
“Close” button.
Note : Do not forget to switch the DIP1 back into OFF position or it would be impossible to
communicate with the device over Ethernet. .
