Huvitz CLM-4000, Service Manual

Page: 11 / 72

10
AUTO-LENSMETER
2. Checking and Setup Method
2.1. Setup Order
When you turn on the power switch, you should hear the beep sound and
see the ROM information. At this point, press the three buttons in the
right side one after another from the rightmost one. Then, after the
beep sound, your lensmeter, CLM-4000 will start in setup and check
mode. While this mode, ‘ SETUP ’ mark will flicker in the left-upper area
of the centric circles. The booting steps with ‘ SETUP ’ mode are as
follows:
A. Turn on the power switch. Then you can hear the beep sound and
see the ROM information.
B. Press the three buttons in the right side one after another from the
rightmost one.
C. Check that ‘ SETUP ’ mark flickers in the left-upper area of the
centric circle .
Setting and Controlling can be processed only in SETUP mode; 0D, prism,
diopter, and right/left switching position of PD. When setting 0D or
SETUP